Check out the video below.
But the software doesn’t see it!
So, how did I put it together?
There’s tape on the back.
So to make the green screen videos I use Adobe After Effects, with the Keylight plug-in. After Effects comes with built in effects for doing things like the fading shown above.
But the only problem is that After Effects doesn’t play any sound, So to find when you should fade in that picture of that next-door neighbor you hate (or whatever) you need to open the video in Quicktime (or whatever) and remember the time you want to queue it and go into After Effects and add in that picture at that mark.
So to record my videos simply with my Flip, which gives me good enough quality.
But if you are going to use a green screen with a flip and After Effects, BEWARE!
You need to export the videos from FlipShare into Quicktime format before using it with after effects or it will be shaky, there will be no sound, or the video will have horrible quality. It took me a few attempts (and failures) to figure THIS one out.
For lighting, I use two White Lightning X1600 with modeling at -2.5f.
So $115 green screens are a thing of the past. Hello cheap DIYs!
Did you make any green screen videos using this?
Upload them to YouTube and comment with the link!
If you want to have your questions answered in front of THAT green screen on a podcast, just send your questions to podcast@goodmorninggeek.com!!
Then, just click on THIS LINK (requires iTunes, click here to download) and download the podcast with your question.
This is a fantastic how-to! I did something similar way back in the day with tons and tons of green paper. Mine actually spanned across my door, and curved smoothly around one of the corners of my room. It also went all the way to the floor, and curved onto a sheet of green paper on the floor. I had mixed results because lighting that surface evenly enough was difficult, since it curved in two directions, and I had an old VHS camera with a very poor CCD (hooked directly up through a composite video cable to a composite video capture device). It wasn’t a great setup. But you are getting fantastic results! I love it!
This is great! Is there any way to do it with Final Cut or iMovie?
Not with iMovie, but there is a way with Final cut.. I can’t tell you how because I can’t afford the software (which is why I review a lot of freeware)